# Getting started

> From a new board to a deck that Companion, the Elgato app or Home Assistant uses.

Source: https://deckconnector.com/docs/getting-started/

1. **Flash.** Connect the board's USB-C port to your computer and open the [flasher](https://deckconnector.com/flash/). It can also join your Wi-Fi. Problems? See [Flashing problems](https://deckconnector.com/docs/flash-troubleshooting/).
2. **Plug in.** The deck goes into the USB-A port. Power the connector with a USB-C power supply, or with a network cable from a PoE port. The deck then shows its address.
3. **Set up.** Open the address in a browser and follow the wizard. See [First setup](https://deckconnector.com/docs/first-setup/).
4. **Connect.** [Companion](https://deckconnector.com/docs/companion/), the [Elgato app](https://deckconnector.com/docs/elgato-app/) or your [own server](https://deckconnector.com/docs/own-server/). The source you pick in setup draws. You can [switch](https://deckconnector.com/docs/hosts/) at any time.

Using [Home Assistant](https://deckconnector.com/docs/home-assistant/)? It finds the connector by itself and gets every key press. It works next to Companion or the Elgato app. For Apple Home or Google Home, turn on [Matter](https://deckconnector.com/docs/matter/).

## The deck menu

While a source draws, hold the first and the last dial for 2 seconds. On a deck without dials, hold the first and the last key. The menu closes after a minute without input.

Next: [First setup](https://deckconnector.com/docs/first-setup/), [Connect Companion](https://deckconnector.com/docs/companion/), [Home Assistant](https://deckconnector.com/docs/home-assistant/)
