# Introduction

> DeckConnector puts an Elgato Stream Deck on Wi-Fi or Ethernet.

Source: https://deckconnector.com/docs/

DeckConnector is free firmware for a small board. The connector drives an [Elgato Stream Deck +](https://www.elgato.com/us/en/p/stream-deck-plus) over USB and puts it on your network. It works like an [Elgato Network Dock](https://www.elgato.com/us/en/p/network-dock-stream-deck), and adds Wi-Fi.

- [Companion](https://deckconnector.com/docs/companion/), the [Elgato app](https://deckconnector.com/docs/elgato-app/) and [your own server](https://deckconnector.com/docs/own-server/) connect at once. You [pick the source](https://deckconnector.com/docs/hosts/) that draws.
- [Home Assistant](https://deckconnector.com/docs/home-assistant/) and [Matter](https://deckconnector.com/docs/matter/) get every key press.
- Wi-Fi and Ethernet at the same time. [When the cable fails](https://deckconnector.com/docs/network/), Wi-Fi takes over.
- [Signed updates](https://deckconnector.com/docs/updates/). A firmware that does not start rolls back by itself.

## What you need

- **Board.** A [Waveshare ESP32-P4-WIFI6-POE-ETH](https://www.waveshare.com/esp32-p4-wifi6-poe-eth.htm), with chip revision v3.1 or later. The flasher checks it. See [Hardware](https://deckconnector.com/docs/hardware/).
- **Deck.** A Stream Deck + (tested). [Other models](https://deckconnector.com/docs/hardware/#decks) should work too.
- **Power.** A USB-C power supply, or a PoE switch port.
- **Computer.** Chrome or Edge, to [flash](https://deckconnector.com/flash/) once.

## Try it first

The [demo](https://deckconnector.com/demo/) runs the real web UI with a virtual deck in your browser. Nothing to install.

Next: [Connect Companion](https://deckconnector.com/docs/companion/), [Elgato app](https://deckconnector.com/docs/elgato-app/), [Benchmarks](https://deckconnector.com/docs/speed/)
