Introduction
DeckConnector puts an Elgato Stream Deck on Wi-Fi or Ethernet.
DeckConnector is free firmware for a small board. The connector drives an Elgato Stream Deck + over USB and puts it on your network. It works like an Elgato Network Dock, and adds Wi-Fi.
The Stream Deck plugs into the connector over USB. The connector joins your network over Wi-Fi, Ethernet or both. Companion, the Elgato app, your own server and a browser reach the deck through the network. Home Assistant and Matter apps get the key presses but draw nothing.
Stream Deck +Your deck, unchanged
DeckConnectorESP32-P4, USB-C or PoE power
Wi-Fi and Ethernetboth at once
On any computer in the network
CompanionSatellite or Network Dock
Elgato appas a Network Dock
Your serverWebSocket protocol
Browserweb UI and API
Only get the presses
Home Assistanttriggers and entities
MatterApple Home, Google Home
- Companion, the Elgato app and your own server connect at once. You pick the source that draws.
- Home Assistant and Matter get every key press.
- Wi-Fi and Ethernet at the same time. When the cable fails, Wi-Fi takes over.
- Signed updates. A firmware that does not start rolls back by itself.
What you need
- Board. A Waveshare ESP32-P4-WIFI6-POE-ETH, with chip revision v3.1 or later. The flasher checks it. See Hardware.
- Deck. A Stream Deck + (tested). Other models should work too.
- Power. A USB-C power supply, or a PoE switch port.
- Computer. Chrome or Edge, to flash once.
Try it first
The demo runs the real web UI with a virtual deck in your browser. Nothing to install.