Skip to content
DeckConnectorSet it up
Skip to Content

First setup

Set up DeckConnector after flashing. Give the connector a name, a password, a network and the source that drives the deck.

With a network cable, scan the QR code on the deck. Without a network, join the setup Wi-Fi the connector opens. Or skip the web UI and enter the address shown on the deck in Companion or the Elgato app. All three end with a source that draws on the deck.

Cable and QR codeThe deck shows its address and a QR code. Scan it with a phone.
Setup Wi-FiNo network yet? The connector opens its own Wi-Fi.
Deck onlyEnter the address from the deck in Companion or the Elgato app.
Then a source draws on the deck

In the browser

The deck shows the connector's address and a QR code. Scan the code with a phone, or open http://<address>/ on a computer in the same network. No address? The connector has no network yet. Join a Wi-Fi in the flasher, plug in a cable, or use the setup Wi-Fi.

Every browser that opens the page goes straight into setup, so you can switch to a phone or a second computer. This works for 30 minutes after the connector starts, until someone sets a password or finishes setup. Later, scan the QR code on the deck instead. It logs you in.

The wizard asks for the name, your own password, the network and the source that controls the deck. The name is also the network name, for example deckconnector-a1b2c3.local. Try the wizard in the demo.

Over the setup Wi-Fi

Before setup is done and without a network, the connector opens its own Wi-Fi. It waits one minute when a cable is plugged in or a Wi-Fi is saved, otherwise it opens at once. You can also start it in the deck menu under Setup Wi-Fi.

Scan the QR code on the deck with the phone camera. The phone joins and opens the page by itself. Without a QR scanner, join the network with the name and password the deck shows. If the page does not open, open any http:// address, or the one on the deck.

The page only asks for your Wi-Fi. You finish setup on your own network.

On the deck alone

The web UI is optional. Plug in a network cable and enter the address from the deck in the Elgato app or in Companion.

When Companion is in the network, the deck shows Companion found. Tap Connect.

On a deck with dials you can set a fixed LAN address in the deck menu under LAN. Turn a dial to change a number, press it for the next field, then tap Save.

Factory reset

  • In the deck menu, hold Restart for 5 seconds, then let go.
  • Or pick Reset on the web login page and confirm twice on the deck.
  • Or, logged in, pick Reset next to Factory reset under Firmware in the web page.

A reset removes every setting, the API keys and passkeys, the paired sources, the Matter pairing, the HTTPS CA, an uploaded certificate, an uploaded web page and the crash report. The new password shows on the deck, and setup starts again.

On this page