Skip to content
DeckConnectorSet it up
Skip to Content

Flashing

Put the firmware on the board from the browser, or with esptool.

In the browser

The flasher writes the latest stable release. It needs Chrome or Edge on a computer.

USB-C goes to the computer for flashing, setup over USB and power. USB-A takes the Stream Deck. The network port takes Ethernet and PoE power. BOOT and RST put the board into download mode.

USB-CTo the computer: flashing, setup over USB, power without PoE
USB-AThe Stream Deck. Not for flashing
EthernetNetwork, and power with PoE
BOOT + RSTDownload mode: hold BOOT, press and release RST, release BOOT

After flashing, the flasher can join your Wi-Fi over the same cable. Everything else follows in the web setup.

The flasher writes only the main chip. The Wi-Fi chip gets its firmware as a normal update.

Something went wrong? See Flashing problems.

With esptool

Use esptool 5 or newer with the files from a release.

esptool --chip esp32p4 -p /dev/ttyACM0 erase-flash
esptool --chip esp32p4 -p /dev/ttyACM0 -b 921600 write-flash 0x0 deckconnector-factory.bin

On Windows the port is COM3 or similar, on macOS /dev/cu.*.

On this page